EMR-5000
IM02602012E
Control - Example: Switching of a Breaker
Ctrl
The following example shows how to switch a breaker via the HMI at the device.
Change into the menu »Control« by pushing the »right arrow« softkey..
Change to the control page by pushing the »right arrow« softkey.
Information only: On the control page a single line diagram with the current
switchgear positions is displayed. By means of the softkey »Mode«
it can be switched
to the menu
»General Settings«. In this menu switching authority and interlockings
can be set.
By means of the softkey »SG«
it can be switched to the menu
»SG«. In this menu
specific settings for the switch gear can be done.
Please note: This control key can be directly called up via the key “CTRL” at the front
panel.
To execute a switching operation, change into the switching menu by pushing the
right arrow softkey button.
www.eaton.com
462
x
QA1
QB1
QB2
x
QA1
QB1
QB2
