Eaton ePDU G3 Troubleshooting Guide P-164000278—Rev 1
www.eaton.com/ePDU
8
Chapter 2
Safety Warnings
IMPORTANT SAFETY INSTRUCTIONS — SAVE THESE INSTRUCTIONS
This manual contains important instructions that you should follow during installation and
operation of the Eaton Enclosure Power Distribution Unit (ePDU) G3. Please read all instructions
before operating the equipment and save this manual for future reference.
DANGER
This ePDU contains
HAZARDOUS VOLTAGES
. All repairs and service should be performed by
AUTHORIZED SERVICE PERSONNEL ONLY
. There are
NO USER SERVICEABLE PARTS
inside the ePDU.
SYSTEMS SHOULD ONLY BE INSTALLED, TESTED, AND CONFIGURED BY A COMPETENT PERSON.
IT IS ESSENTIAL THAT THIS EQUIPMENT IS CONNECTED TO AN ELECTRICAL SUPPLY THAT HAS
PROTECTIVE GROUND CONDUCTOR.
CAUTION
l
To reduce the risk of fire or electric shock, install this Eaton ePDU in a temperature and humidity
controlled, indoor environment, free of conductive contaminants. Do not operate near water or
excessive humidity (95% maximum).
l
Both the room and rack air temperature must be within the operating range of the selected
model.
l
Do not use a two-wire power cord in any product configuration.
l
Test AC outlets at your computer and monitor for proper polarity and grounding. Use only with
grounded outlets at both the computer and monitor.
l
The installation power outlet used for the power supply to this equipment must be installed near
the equipment and must be easily accessible.
l
When installing this product, it is essential that the distribution circuit supplying the product is
protected by a branch circuit protection device with a maximum rating to suit the product
maximum rating.
l
TO ISOLATE THIS EQUIPMENT, DISCONNECT ALL OF THE POWER SUPPLY PLUGS.
l
This product has been designed to conform to the latest safety requirements. In addition to
compliance with standards for general use, it has been factory configured for use in rack
mounting environments, aiding the installer in providing systems compliant with relevant
standards.
l
Only use supplied ePDU mounting hardware and accessories. If necessary, contact your
customer service representative for replacement parts.
l
This equipment is intended for installation in Restricted Access Locations such as computer
rooms, network closets, and equipment racks.
