7
Installation Guide: EV wall charger and EV wall charger plug-in
EV WALL CHARGER AND EV WALL CHARGER PLUG-IN
www.eaton.com
Installation
Important safety instructions
DANGER
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
DEATH, PERSONAL INJURY, OR PROPERTY DAMAGE. CIRCUIT
BREAKERS MUST BE INSTALLED AND SERVICED BY A QUALIFIED
ELECTRICIAN. REMOVE ALL POWER SOURCES TO THE PANEL
BEFORE STARTING INSTALLATION OR MAINTENANCE.
WARNING
THIS EQUIPMENT SHOULD BE INSTALLED, ADJUSTED, AND
SERVICED BY QUALIFIED ELECTRICAL PERSONNEL FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THIS TYPE OF
EQUIPMENT AND THE HAZARDS INVOLVED. FAILURE TO OBSERVE
THIS PRECAUTION COULD RESULT IN DEATH OR SEVERE INJURY.
READ THIS MANUAL THOROUGHLY AND MAKE SURE YOU
UNDERSTAND THE PROCEDURES BEFORE YOU ATTEMPT TO
OPERATE THIS EQUIPMENT. THE PURPOSE OF THIS MANUAL IS
TO PROVIDE YOU WITH INFORMATION NECESSARY TO SAFELY
OPERATE, MAINTAIN, AND TROUBLESHOOT THIS EQUIPMENT.
KEEP THIS MANUAL FOR FUTURE REFERENCE.
DO NOT USE THIS PRODUCT IF THE EV CONNECTOR CORD IS
FRAYED, HAS DAMAGED INSULATION, OR HAS ANY OTHER
INDICATION OF DAMAGE.
DO NOT USE THIS PRODUCT IF THE EV SMART BREAKER CHARGER,
THE EV CONNECTOR, OR THE LOADCENTER IS BROKEN, CRACKED,
OPEN, OR SHOWS ANY OTHER INDICATION OF DAMAGE.
INTENDED FOR USE WITH PLUG-IN ELECTRIC VEHICLES ONLY.
PREMISE VENTILATION NOT REQUIRED.
THIS DEVICE SHOULD BE SUPERVISED WHEN USED AROUND
CHILDREN.
WARNING
TURN OFF OR DISCONNECT THE POWER SUPPLYING THIS
EQUIPMENT BEFORE BEGINNING WORK. THIS MAY REQUIRE THAT
YOU CONTACT YOUR ELECTRIC UTILITY TO DISCONNECT POWER TO
AN EXISTING LOADCENTER. THE LINE SIDE OF THE MAIN BREAKER
IS ENERGIZED UNLESS POWER IS DISCONNECTED UPSTREAM.
EATON WILL NOT ASSUME RESPONSIBILITY FOR PROPERTY
DAMAGE OR PERSONAL INJURY RESULTING FROM MISUSE OF THE
INFORMATION IN THIS PUBLICATION.
NOTICE
INSTALL EQUIPMENT IN CONFORMANCE WITH CODES.
Grounding instructions
WARNING
IMPROPER CONNECTION OF THE EQUIPMENT-GROUNDING
CONDUCTOR IS ABLE TO RESULT IN A RISK OF ELECTRIC SHOCK.
CHECK WITH A QUALIFIED ELECTRICIAN OR SERVICEMAN IF YOU
ARE IN DOUBT AS TO WHETHER THE PRODUCT IS PROPERLY
GROUNDED.
For a permanently connected product
This product must be connected to a grounded, metal,
permanent wiring system, or an equipment-grounding
conductor must be run with the circuit conductors and
connected to the equipment grounding terminal or lead on
the product .
REFERENCE THE QR CODE ON THE EV SMART BREAKER
CHARGER FOR LATEST DOCUMENTATION AS THE
INFORMATION CONTAINED IN THIS MANUAL IS SUBJECT
TO CHANGE .
This product must be installed in accordance with the
National Electrical Code
®
(NEC
®
) and any applicable local
codes . Before installing equipment, check with your local
electrical inspector for requirements and information . If you
have questions or need assistance, contact a qualified elec-
trical contractor .
SAVE THESE INSTRUCTIONS
.
