24
Commissioning and start-up
OperatiOnal manual
MN156001EN October 2015 www.eaton.com
Adjust date and time
Set the date time for the active filter as follows:
1.
Touch the screen to open an editable screen.
2.
Touch the hour, minutes, seconds, date, and year to
open a numeric keypad to enter the date and time. Touch
the month to display arrows, scroll to the appropriate
month and press Enter.
3.
Press OK.
Check fan
Test each fan individually as follows.
1.
Press Enclosure and listen for any unusual sounds.
2.
Press Heatsink and listen for any unusual sounds.
If you hear no sound at all or if you hear mechanical
rubbing, contact Technical Support.
3.
Press Next if both fans are operating normally.
System Integrity Test
This test verifies that the unit can generate current and
provide current correction.
The unit can either operate in Capacitive or Inductive modes
for this test. The loads operating on the system determine
which mode is best for the application.
•
Capacitivee:
This mode is typically the correct mode for
operating the unit for most applications. If the loads
are mostly inductive, motors, or VFDs, the system has
a lagging power factor. Operating in Capacitive mode
improves the power factor and reduces the total kVA of
the system during the test
•
Inductivee:
This mode is for applications with a leading
power factor. Operating in Inductive mode corrects for a
leading power factor facility.
