43
USER MANUAL FERNTEL IP4 / IP160
March 2022 www.eaton.com
Type: Partner
Selection parameter set to function type
Partner
.
Text:..................
Input parameter for optional specification of caption text.
Icon:..................
Selection parameter for specifying an icon.
Number:................
Input parameter to specify the phone number of the partner phone.
Display number.........
Open the dialog below to set the partner statuses that are to be shown in this phone’s display.
calling:...............
Selection parameter to display the partner status “calling.”
Off
Partner status “calling” is not displayed.
On
Partner status “calling” is displayed.
connected:.............
Selection parameter to display the partner status “connected.”
Off
Partner status “connected” is not displayed.
On
Partner status “connected” is displayed.
Presence:..............
Selection parameter for display of partner presence.
Off
Partner presence is not indicated.
On
Partner presence is indicated.
5.1.6.6.4 “Park” function for selected key f
The f function key causes a connection to be parked in the position specified in the dialog. Pressing the key causes your
conversational partner to be parked. You end the connection, for example, by hanging up the receiver, and then resume
the conversation on the device specified in the dialog.
Type: Park
Selection parameter set to function type
Park
.
Text:.................
Input parameter for optional specification of caption text.
Icon:.................
Selection parameter for specifying an icon.
Number:...............
Input parameter to specify the phone number of the object on which the conversation is to be parked.
Position:.............
Input parameter to specify an additional park position, typically 0.
Display number.........
Open the dialog below to specify display options.
calling:............
Selection parameter to specify the “calling” display option.
Off
Display phone number of the parked subscriber.
On
Suppress phone number of the parked subscriber.
5.1.6.6.5 “Pickup” function for selected key f
Function monitors the states of the phones of the own call group and signals calls to these phones in the display. Function
key f causes these optically signaled calls to be accepted. The calls from phones in the call group are indicated in the form
CGPN
CDPN
(caller
call recipient) in the bottom right in the display’s viewing area. If multiple calls occur simultaneously,
a list of
CGPN
CDPN
entries is shown, from which the call can be selected, which should be accepted by pressing the
function key f.
Type: Pickup
Selection parameter set to function type
Pickup
.
State:.................
Selection element for setting the function state
1
Phones in the call group are in idle mode or busy; pressing function key f has no effect.
2
At least one phone in the call group is called; pressing function key f causes this call to be accepted.
Text:
[1][2]
...............
Input parameter for optional specification of caption text.
Icon:
[1][2]
...............
Selection parameter for specifying an icon.
LED:
[2]
.................
Selection parameter to specify the LED operating mode in state 2.
Display number.........
Open next dialog to specify the call signaling.
calling:.............
Selection parameter to specify the call signaling.
Off
Call signaling is done in the form
CDPN
.
On
Call signaling is done in the form
CGPN
CDPN.
Requirements
The PBX used must support the partner function feature, both phones must belong to the same group, and the partner function must
be enabled.
Requirements
- The PBX used must support the partner function feature, both phones must belong to the same group, and the partner function must
be enabled.
