Flexi -3G Installation & Commissioning Manual
Chapter 3. Installation Procedure
Page 30 of 94
Document No: - 4493-CM-EN-10989402
Copyright © 2008-2009 Eaton Corporation. All Rights Reserved
3.4. Securing the Battery Cabinet
6
Floor Securing Bracket
18
M10 Floor Anchor Bolt to
suit Flooring Type
19 Washer Plain M10
20 Washer Locking M10
Fig. 3-8 Securing the Battery Cabinet
The Battery Cabinet is mounted directly to the floor. The method of fixing must be suitable for the
cabinet size and weight, and for the surface to which the cabinet is being secured.
1.
Place cabinet in position.
2.
Mark the fixing holes through the base and rear of the cabinet with a permanent marker.
3.
Remove cabinet.
4.
Drill all marked holes. De-burr all holes.
5.
Place cabinet back in position.
6.
Place the 4 Floor Securing Brackets in position over the fixing holes in the Side Panels and on top
of the Battery Support Bars.
7.
Fix cabinet using appropriate floor anchors to secure the cabinets.
8.
Tighten the Floor Securing Bracket Fixings to the torque specified by the manufacturer.
9.
If required, fix the cabinet to the wall using appropriate wall anchors to secure the cabinets.
10.
Tighten the Wall Anchor Fixings to the torque specified by the manufacturer.
6 18 19 20
Wall Fixing Holes
