12
8.0 EV charge station Commissioning Tool install and setup
Green Motion BuildinG and Green Motion FleetcoMMissioninG Guide
IL191013EN June 2023 www.eaton.com
8.2 Connect your computer to the EV charge station
Use an Ethernet cable to safely connect your computer and the EV charge station. The
Ethernet port is accessible at the bottom surface of the EV charge station. Once connected,
the Ethernet icon on the EV charge station LCD will turn ON.
Figure 15. Use Ethernet cable to connect computer with EV charge station
8.3 Update TCP/IP settings on your computer
ote:
N
These instructions are also displayed in detail when you click the Set Up button
on the Commissioning Tool.
ote:
N
If your computer is on a company network, please contact your IT department
for assistance.
1.
Access the TCP/IP settings from your computer’s Control Panel -> Network and Internet
-> Network and Sharing Center -> Change Adapter Settings.
2.
Right click on the ‘Ethernet’ connection (connected to EV charge station) and select
Ethernet Properties -> Networking Tab -> Internet Protocol Version 4 (TCP/IPv4).
Select this setting and click Properties. See image below.
Figure 16. Ethernet connection properties
