Installing Battery Cabinets
3-21
EATON
Powerware
®
9390 Integrated Battery Cabinet (Models IBC-S and IBC-L) Installation Manual
S
164201536 Rev D
www.eaton.com/powerquality
6.
Remove the cosmetic cover and hanger brackets from the appropriate side or
sides of the battery cabinets, depending on the position of the cabinets. Save
covers, screws, and brackets for later use.
7.
Roll the next battery cabinet to be joined to an area near the appropriate side of
the first battery cabinet.
8.
Push the battery cabinet to be joined towards the first battery cabinet until the
doors are flush with each other.
9.
Secure the battery cabinet position by lowering the leveling feet until the cabinet
is not resting on the casters. Ensure the cabinet is level and matches the height of
the first installed battery cabinet.
NOTE
Two cabinet joining brackets are provided for securing each cabinet at the top
and bottom. A flat bracket joins the top of the cabinets and a larger flat bracket joins
the cabinets at the bottom. The small flat bracket is attached to the cabinet tops first.
10.
Remove the left‐hand and right-hand screws from the adjacent top door hinges of
the battery cabinets.
11.
Locate the small flat bracket from the field kit. Align the holes in the small flat
bracket over the hinge screw holes. Replace the screws in the hinges, securing the
bracket to the cabinets (see Figure 3‐9).
12.
Locate the large flat bracket from the field kit. Place the bracket over the bolts on
the bottom side of the adjacent lower hinges on the battery cabinets (see
Figure 3‐10).
13.
Secure the bracket to the hinges with hardware from the field kit.
14.
Route the ground wire (from the field kit) from the ground stud in one battery
cabinet, under the lower battery tray and through the cabinet-to-cabinet cable
access area in the side of the cabinets, and attach to the ground stud in the other
battery cabinet (see Figure 3‐10 and Figure 3‐11). Hardware is provided on each
ground stud.
15.
If installing additional battery cabinets, repeat Steps 6 through 13 to join each
additional battery cabinet; otherwise, proceed to Step 15.
16.
If not already installed, mount the hanger brackets to the top appropriate side of
the last battery cabinet using M4 screws (see Figure 3‐5).
17.
If not already installed, hang the side panel on the hanger brackets and align with
the front and rear of the battery cabinet.
18.
If not already secured, secure the side panel at the bottom using M4 hex-head
screws previously removed.
19.
