Installing Battery Cabinets
3-15
EATON
Powerware
®
9390 Integrated Battery Cabinet (Models IBC-S and IBC-L) Installation Manual
S
164201536 Rev D
www.eaton.com/powerquality
NOTE
When cabinets are properly aligned, all cabinet doors are flush.
Bracket
from Kit
Existing Screws
Top View with Small Bracket
Battery Cabinet
UPS Cabinet
Large Bracket
Figure 3‐9. UPS to IBC-L Joining Brackets
4.
If necessary, remove the cosmetic cover and hanger brackets from the left‐hand
side of the UPS. Save cover, screws, and brackets for later use.
5.
If necessary, remove the cosmetic cover and hanger brackets from the right‐hand
side of the battery cabinet. Save cover, screws, and brackets for later use.
6.
Remove the knockout plug on the bottom left side of the UPS cabinet inside
panel. Refer to Appendix A of the appropriate Powerware 9390 UPS Installation
and Operation Manual, as referenced in paragraph 1.6, for the location of the
knockout plugs.
7.
Install the nylon grommet from the field kit around hole left after removal of
knockout plug.
8.
Push the battery cabinet toward the UPS cabinet until the doors are flush with
each other.
9.
Secure the battery cabinet position by lowering the leveling feet until cabinet is
not resting on the casters. Ensure the cabinet is level and matches the height of
the installed UPS cabinet.
