IQ 100 Series (130/140/150) Meter
Programming the Meter Using the Front Panel
46 User and Installation Manual IM02601003E-July 2010 www.eaton.com
Entering a Password
If Password Protection has been enabled in the software for Reset and/or Configuration (see page 58 for
information), a screen appears requesting a Password when you try to reset the meter and/or configure
settings through the front panel.
• PASS appears in the A window and 4 dashes appear in the B window. The leftmost dash is
flashing.
1. Press the Down button to scroll numbers from 0 to 9 for the flashing dash. When the correct number
appears for that dash, use the the Right button to move to the next dash.
Example: The left screen, below, shows four dashes. The right screen shows the display after the
first two digits of the password have been entered.
2. When all 4 digits of the password have been selected, press the Enter button.
• If you are in Reset Mode and the correct Password has been entered, “rSt All donE” appears
and the screen resumes auto-scrolling parameters.
• If you are in Configuration Mode and the correct Password has been entered, the display
returns to the screen that required a password.
• If an incorrect Password has been entered, “PASS ---- FAIL” appears, and:
• The previous screen is redisplayed, if you are in Reset Mode.
• The previous Operating Mode screen is redisplayed, if you are in Configuration Mode.
