MGR10 A/B/C - Revision : I (for 7.0 software revision)
31
4.5 Limits
Press on :
To select the Limits menu.
Two options are then available ,
[Meas]
which enables limits to be set with reference to the
measured values or
[O/C]
which enables the open circuit voltage to be limited to either 20mV or 50
mV( NFC93050 standard B , C conditions )
Meas :
Press on
[Meas]
to call the measurement limits menu.
Press on
[Alm]
to activate or not the audible alarm
.
Press on
[On]
to activate the audible signal when measurement result fails
Or press on
[Off]
to cancel the audible alarm .
Press on [
OK
] to go back to the previous page
Press on
[Max]
to set the maximum value
Press on
[Chg]
, lto change the value , then enter the new value in Ohm in using the
numeric keypad .
Press on
[OK]
to enter the value.
Press on
[OK]
to go back to the previous page
Press on
[Min]
to set the minimum value and proceed the same way for the upper limit .
Press on [
On]
to activate the comparison mode
Press on
[Off]
to cancel the comparison mode.
Press on
[OK]
to go back to the previous page
CLE
LIM.
LIMIT
Limits :
Meas O/C
Quit
