Eaton Network Card-MS Quick Start Instructions P-164000507—Rev 1
5
Section 2
Install the Card
Note:
The hot-swappable Network Card-MS card can be installed without
turning off the UPS or disconnecting the load.
To install the Network Card-MS card:
1.
Remove the minislot cover from the UPS. Retain the screws.
2.
If not already done, record the card’s MAC address from the label on the
card for future reference (see Step 2 in the “Installation Checklist”).
Note:
If another card is already installed with an attached communication
cable, disconnect the cable and then remove the card.
3.
To prevent electrostatic discharge (ESD), place one hand on a metal surface,
such as the UPS rear panel.
4.
Slide the card into the open slot and secure it with the screws removed in
Step 1 (see Figure 1).
Figure 1. Installing the Card
ACT
100M
MAC:
ETHERNET
Settings/Sensor
RS232
UPS Data
Summary of Contents for Network Card-MS
Page 25: ......
Page 26: ...164950239 P 164000507 1...
