Eaton Network Card-MS Quick Start Instructions P-164000507—Rev 1
6
Section 3
Connect the Card to the Computer
Note:
You can set the card parameters through the Settings/Sensor port even
if the network is not connected.
Note:
You cannot use the Ethernet port for configuration.
Note:
When the card is not connected to the network, it continuously
attempts to connect. When the connection is established, the LEDs
indicate the status.
To connect the card to the computer and the network:
1.
Verify that the UPS is on and in normal mode.
Note:
If you are not sure how to know if the UPS is in normal mode, refer to
the User’s Guide for your UPS.
2.
Plug the RJ-45 end of the supplied configuration cable into the
Settings/Sensor port on the card (see Figure 2).
3.
Plug the other end of the serial cable into the serial COM port on the
computer. (Depending on your laptop, you may need an adapter for this
step.)
4.
Connect an active Ethernet cable (not supplied) from the network
connection to the Ethernet port on the Network Card-MS (see Figure 2).
Figure 2. Connecting the Card
5.
Wait approximately two minutes until the green UPS Data LED flashes
regularly, indicating normal operation.
ACT
100M
MAC:
ETHERNET
Settings/Sensor
RS232
UPS Data
Ethernet Cable
Configuration Cable
Summary of Contents for Network Card-MS
Page 25: ......
Page 26: ...164950239 P 164000507 1...
