Eaton Network Card-MS Quick Start Instructions P-164000507—Rev 1
7
Section 4
Initialize the Card Configuration
Note:
These instructions are for HyperTerminal, but you can use the terminal
emulation program of your choice, such as HyperTerminal or PuTTY.
Note:
Before you start initializing the card configuration, you will need to know
which COM port you are using on your computer.
To initialize the card configuration:
1.
Verify that the serial cable (supplied) connects the card’s Settings/Sensor
port to the computer’s COM port. Also verify that the UPS is on and in
normal mode.
2.
Click
Start
in the computer Start bar. Type
Device
in the search box. Select
Device Manager
in the list above the search box. The Device Manager
opens.
3.
Locate
Ports (COM & LPT)
in the list and click the adjacent “plus box” to
expand the selection. Make a note of the COM port you are using.
4.
Open HyperTerminal.
5.
Respond
Yes
or
No
to the message asking if you want to make
HyperTerminal your default terminal emulation program.
6.
Optional.
When the Connection Description dialog box opens, enter a name
for this connection and click
OK
. Otherwise, click
Cancel
.
7.
In the New Connection Window, make the menu selection
File > Properties
. On the screen that displays, select
New Connection
Properties
.
8.
From the “
Connect Using...
”drop-down list, select the COM port that you
are using (see Figure 3).
Summary of Contents for Network Card-MS
Page 25: ......
Page 26: ...164950239 P 164000507 1...
