Eaton Network Card-MS Quick Start Instructions P-164000507—Rev 1
8
Figure 3. Selecting the COM Port
9.
Click
Configure
.
10. In the COM Properties dialog, click
Restore Defaults
to set the correct baud
rate, data bits, stop bit, and flow control.
11. Click
OK
.
12. At the blinking screen, press
Enter.
You should be prompted enter the
password (default is
admin
).
Note:
If the Password prompt does not appear, press
Enter
again. If it still
does not appear, check the following conditions:
l
Verify the serial line is set to 9600 baud, no parity, 8 data bits, 1 stop bit,
and no flow control.
l
If the serial line settings are correct, check the cabling to verify all
connections are secure.
l
Verify that your terminal program is set to the correct communication port
for the serial connection.
l
Verify that the card has power (one or more LEDs on the card are
illuminated). The UPS should be turned on.
Summary of Contents for Network Card-MS
Page 25: ......
Page 26: ...164950239 P 164000507 1...
