Data interrogation
33
11/04 MN01219002Z-EN
Represent.
The DMI is factory set to display all currents as relative
values, i.e. as % values of
I
r
. It is therefore factory set to
correspond to the markings on the NZM. However, absolute
values are also possible in Amps.
X
Make the selection in the Represent. display menu.
The following screen shows Absolute and the setting Y (=
Yes) or N (= No).
X
Use the cursor buttons to select between Y and N.
X
Confirm the setting with
OK
.
Incorporating values in the Standard display
For example, you can show important parameters, the status
of the digital inputs and the current time in the display.
X
Select a submenu, e.g. Currents in the Display menu.
X
Use the cursor buttons
Í
or
Ú
to select the required
parameter, e.g.
I
1
.
X
Confirm the selection by pressing
OK
.
The value for
I
1
is incorporated in the Standard display (
a
following Section “The standard display”).
The standard display
X
In the main menu use cursor buttons
Í
or
Ú
to select
Display.
X
Confirm your selection by pressing
OK
.
REPRESENT.
Absolute (Y/N)
h
The standard display appears automatically in the LCD
display if buttons on the DMI have remained in a non-
actuated state for 30 seconds or longer. It is only
overwritten by alarm messages from the NZM (
a
section
“Alarm messages”, Page 66).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
