Eaton OSHPD Install Instructions Manual Download

Page: 1 / 6

Eaton 93PM UPS (208–480V) Seismic (OSHPD) Door Retention Kit Install Instructions

P-164000883—Rev 01

EEaattoonn 9933P

M U

S ((220088––448800V

V)) S

Seeiissm

miicc ((O

D)) D

Doooorr R

Reetteennttiioonn K

Kiitt IInnssttaallll IInnssttrruuccttiioonnss

Use these instructions to install the seismic door retention kit brackets to secure the uninterruptible power
supply (UPS) door. One kit is required per UPS door.

These instructions are applicable to all UPS frame sizes for the following models:

•

Eaton 93PM-L UPS (208V)

•

Eaton 93PM UPS (480V)

NOTE 1

This kit is used to support seismic installations where applicable.

NOTE 2

Refer to the installation and operation manual supplied with the UPS for dimensions and
required clearances.

Seismic Door Retention Kit Contents

Quantity

Bracket, 93PM Cabinet, OSHPD

Bracket, 93PM Door, OSHPD

Flange Head Bolt, Black M5 X 12

NOTE

See

Figure 1

for door retention kit details.

IMPORTANT

For seismic installations, the UPS cabinet floor mounting surface must be level.

To install the brackets:

Unload and mechanically install the UPS according to the instructions in the applicable installation and
operation manual.

Open the UPS door. Locate the horizontal slot on the top rear of the door. See

Figure 2

for the bracket

horizontal slot location.

Remove the two M4 screws directly beneath the opening. See

Figure 2

for the screw location.

Install the door bracket and secure with two M4 screws previously removed. Hand tighten the screws.

Install the cabinet bracket using the two M5 thread forming screws included in the kit. Hand tighten the
screws. See

Figure 3

for cabinet bracket mounting location and

Figure 4

bracket installation details.

Both brackets have slots for adjusting bracket position. Adjust brackets so the spring-loaded fastener on
the cabinet bracket aligns with the threaded insert of the door bracket.

Once the brackets are properly aligned, secure the brackets by tightening the screws to the following
torque specifications.

Door bracket M4 screws

2.0–3.3 Nm, or 18–29 in-lbs.

Cabinet bracket M5 screws

4.1–6.6 Nm, or 36–58 in-lbs.

Close and secure the UPS door.