32
EIA hole pattern
Use this hole
Use this hole
Use this hole
Use this hole
RACK MOUNTED ROLL-OUT SHELF
WARNING! The enclosure rack must be stabilized before installing any roll-out type accessory com-
ponent or electronic device into the rack. Failure to stabilize the rack before installing equipment may
cause the enclosure to tip over.
1. Refer to figure
9-25
and then using the numbers on the rails as a guide, locate the four holes that define your de-
sired shelf level. If your rails have a 3/8” square hole pattern, then snap four #10-32 clip nuts onto each rack
mount rail at the same U level. Clip nuts are not required on rails with pre-threaded EIA holes. See figure
9-25
.
2. Disengage the Slides from the roll-out shelf. The
Chassis Disconnect Slide
member will remain fixed to the
shelf. See figure
9-26
.
3. Adjust the rear slide brackets to accommodate the front-to-back measurement of your rack mount rails.
Figure
9-2
5
Figure
9-2
6
R.H. Chassis
member
R.H. Slide
Push in to
disengage
Roll-Out shelf
Pull to
disengage
Clip nuts
Rack mount rail
1-3/4”(1.75”)
Pub Num: MN159002EN rev1.0
Paramount Enclosure
Installation Guide
Summary of Contents for Paramount Enclosure
Page 1: ...Eaton Data Center Racks...
Page 2: ...U...