Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01
27
44..44..11
A
Allaarrm
m N
Noottiiffiiccaattiioonn bbyy EEm
maaiill
The BCMS Hub can email a summary alarm notification by Simple Mail Transfer Protocol (SMTP). A TCP/IP
connection to the BCMS Hub must be connected and initialized. The IP address of the SMTP server, domain,
name, “from” email address, and the recipient’s email address are set on the
screen.
The user can check that device for more specific information. The
Event Log
will also describe the alarm
condition.
Figure 19. Email Setup Screen
To setup Email Notification, touch the
tab on any screen (
). Enter email Server, Domain, Name,
and email to/from names using screen buttons.
To have emails sent to a list of contacts within an organization, setup a group email address through your mail
portal and use this address as the
To
address on the
screen.
The
Send Email
box has a red X when email notification is not enabled. Toggle the box to a green check mark
to send email alarm notifications.
44..44..22
A
Allaarrm
m N
Noottiiffiiccaattiioonn bbyy M
Mooddeem
m
A 9600 bps dial-out modem is a configurable option. When this option is selected, the modem is installed on
the Monitor backpanel. Touch the Modem tab to display the Modem screen (
). The modem can be
used to send a summary alarm to one or two specified destinations.
Summary of Contents for PDI WaveStar BCMS
