22
Eaton PDI WaveStar BCMS Hub Installation and Operation Manual P-164001108—Rev 01
44..11..33
IInniittiiaall A
Addm
miinniissttrraattoorr A
Acccceessss
To initially set up BCMS Hub users, Eaton provides a temporary Administrator PIN and password. The initial
PIN.password
is 100.23223. The administrator should:
1.
Log in on the
Home
screen.
2.
Navigate to the
Users
screen.
3.
Change the administrator
PIN
and
password
and then keep them secure.
4.
Set up each user’s security information as described in the following sections.
After initial startup, commissioning, testing, or restart, the administrator should clear any alarms that occurred.
Alarms must be separately cleared on each device that has alarms.
44..11..44
U
Usseerrss S
Sccrreeeenn
Figure 15. Users Screen
Touch the
User
button at the bottom of a display screen to display the
Users
Screen (
The
Users
screen
•
lets the Administrator set up new users and their level of access to the BCMS Hub, and
•
displays the names of registered users and unassigned slots.
Scroll through the user list using the scroll bar on the right side of the screen to highlight a user name.
Set up or modify a user’s profile using the
Name
,
PIN
,
Password,
and
Class
buttons. Each user must be
assigned a password and PIN.
•
The Administrator sets a user’s access class by touching the
Class
button and entering the first letter of
the class:
Summary of Contents for PDI WaveStar BCMS
