30
Eaton Power Xpert 9395C UPS Installation and Operation Manual 164000821—Rev 06
Do not install a damaged cabinet. Report any damage to the carrier and contact an Eaton service representative
immediately.
Ne pas installer une armoire endommagée. Signaler les dommages au transporteur et communiquer avec un
représentant du service Eaton immédiatement.
NOTE
For the following step, verify that the forklift or pallet jack is rated to handle the weight
of the cabinet (see
for cabinet weight).
2.
Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking.
If possible, move the cabinet using the pallet. Insert the forklift or pallet jack forks from the right side of the
pallet (facing the cabinet), between the supports on the bottom of the pallet (see Carefully inspect the
outer packaging for evidence of damage during transit. See
for the UPS cabinet center of gravity
measurements).
If the cabinet must be moved using the cabinet front or rear fork lift slots, see the caution statement at the
beginning of this procedure.
Do not tilt the UPS cabinet more than 10º from vertical or the cabinet may tip over.
Ne pas incliner les armoires d’onduleur à plus de 10 degrés de la verticale puisqu’elles pourraient se renverser.
3.
Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
NOTE
The ISBM and PM sections are shipped with debris shields covering the ventilation grills
on top of the sections (see
). Do not remove the debris shields until installation
is complete.
4.
Remove the protective covering from the cabinet.
5.
Remove the packing material, and discard or recycle in a responsible manner.
6.
Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading.
If damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
NOTE
While waiting for installation, protect the unpacked cabinets from moisture, dust, and
other harmful contaminants. Failure to store and protect the UPS properly may void your
warranty.
Summary of Contents for Power Xpert 9395C
Page 8: ......
Page 175: ...16400082106 164000821 06...
