40
Eaton Power Xpert 9395C UPS Installation and Operation Manual 164000821—Rev 06
Lors de l’installation, prendre soin de protéger les composantes du côté droit du module de contournement de
système intégré (ISBM) et les faisceaux de câbles reliant les armoires du côté gauche du module
d’alimentation universel (PM).
NOTE
The step that follows temporarily places the ISBM section apart from the PM section to
allow a gap for electrical connection access.
4.
Using a forklift with the forks in the front forklift slots, position the ISBM section adjacent and staggered to
the left side of the previously installed PM section (
).
Figure 18. ISBM to PM Access
ISBM to PM gap
(Temporary for
Electrical Connection Access)
ISBM
PM
ISBM Wireway
(Power wiring harnesses are coiled in this area.)
44..33..22
EElleeccttrriiccaallllyy C
Coonnnneeccttiinngg tthhee U
UP
PS
S S
Seeccttiioonnss
1.
Unfasten the front door latch and swing the door open (see
2.
Remove the door. Remove the retaining screw located inside the door at the bottom hinge pivot point,
then lift the door off. Retain the hardware for later use.
3.
Remove the screws securing the ISBM section right bottom internal safety shield panel and remove the
panel to gain access to the internal input, output, and battery terminals. Retain the hardware for later use.
NOTE
AC and DC input intercabinet power wiring harnesses are supplied coiled and secured in
the ISBM wireway on the right side of the ISBM section (see
).
Summary of Contents for Power Xpert 9395C
Page 8: ......
Page 175: ...16400082106 164000821 06...