72
Eaton Power Xpert 9395C UPS Installation and Operation Manual 164000821—Rev 06
Figure 41. Powerware Hot Sync CAN Bridge Card.
Plug-in Terminal
Block J3
NOTE
Only one Powerware Hot Sync CAN Bridge Card can be installed in the UPS. Multiple
CAN cards are not supported and will cause system conflicts.
To install the card:
1.
Verify the UPS system is turned off and all power sources are removed. See
for shutdown instructions.
2.
Unfasten the front door latch and swing the door open (see
3.
Install the Powerware Hot Sync CAN Bridge Card into an open X-Slot communication bay on the front of
the UPS. See
for X-Slot communication bay locations.
To locate the appropriate terminals on the Powerware Hot Sync CAN Bridge Card, see
and
.
Summary of Contents for Power Xpert 9395C
Page 8: ......
Page 175: ...16400082106 164000821 06...