1.
If not already accomplished, use a forklift or pallet jack to move the cabinet to the installation area,
or as close as possible, before unloading from the pallet. If possible, move the cabinet using the
pallet. Insert the forklift or pallet jack forks from the right side of the pallet (facing the cabinet), be-
tween the supports on the bottom of the pallet (see Figure 3-6 on page 11 for the FI-UPM cabinet
center of gravity measurements).
2.
Remove the three bolts securing the left side shipping bracket to the cabinet and three bolts
securing the bracket to the pallet (see Figure 4-1). Remove the left side shipping bracket. If
installing the cabinet permanently, retain the shipping bracket and securing hardware for later use.
Figure 4-1. Removing the Left Side Shipping Bracket
3.
Remove the three bolts securing the right side shipping bracket to the cabinet and three bolts
securing the bracket to the pallet (see Figure 4-2). Remove the right side shipping bracket.
4.
Using a forklift, raise the FI-UPM cabinet section until the cabinet bottom clears the pallet by
approximately 3 mm.
5.
Pull the pallet from under the FI-UPM cabinet.
6.
Discard or recycle the pallet and unused shipping brackets in a responsible manner.
7.
Carefully lower the FI-UPM cabinet until the cabinet base contacts the floor.
1
Shipping Bracket Bolts
2
FI-UPM Removable Front Panel
3
Pallet
4
Left Side Shipping Bracket
1
2
3
4
Summary of Contents for Power Xpert 9395P
