Eaton Power Xpert 9395P, Mechanical Installation Manual

4.4 Electrical Installation

Install FI-UPM battery wiring from the battery cabinet to the FI-UPM battery terminal location in the 
UPS (refer to the applicable UPS manual listed in Section 1.4 on page 3). Wiring between the FI-UPM 
and the UPS, and FI-UPM battery terminals will be installed by an Eaton Customer Service Engineer. 
This service is offered as part of the sales contract for the FI-UPM. Contact an Eaton service 
representative in advance (usually a two-week notice is required) to request service.

4.5 Initial Startup

Startup and operational checks must be performed by an authorized Eaton Customer Service Engineer, 
or the warranty terms specified on page 23 become void. This service is offered as part of the sales 
contract for the FI-UPM. Contact an Eaton service representative in advance (usually a two-week 
notice is required) to reserve a preferred startup date.

4.6 Completing the Installation Checklist

The final step in installing the FI-UPM is completing the following Installation Checklist. This checklist 
ensures that all hardware, cables, and other equipment have been completely installed. Complete all 
items listed on the checklist to ensure a smooth installation. Make a copy of the Installation Checklist 
before filling it out, and retain the original.

After the installation is complete, an Eaton Customer Service Engineer must verify the operation of the 
FI-UPM and UPS system and commission it to support the critical load. The service representative will 
verify software and operating setup parameters. Service personnel may request a copy of the 
completed Installation Checklist to verify all applicable equipment installations have been completed.

NOTE

The Installation Checklist MUST be completed prior to starting the FI-UPM and UPS system for 
the first time.