2
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
IInnssttaallll tthhee C
Caarrdd
NOTE
The hot-swappable PXGMS card can be installed without turning off the UPS or
disconnecting the load.
NOTE
If your UPS is a 93PM, there may be a metal strip that prevents you from installing the
PXGMS card. If so, locate the metal strip bolted to the top of the UPS. Remove the
three bolts that attach the metal strip. Then, follow the procedure to install the PXGMS
card.
To install the PXGMS card:
1.
On the PXGMS card, verify that all six DIP switches are in the
OFF
position (see
).
Figure 1. Verify DIP Switches are OFF
Ide
nt
Po
we
r
Act
100
PX
GM
S U
PS
Res
tart TX
RX
Set
up
CM
N
Sta
tus
DH
CP
EM
P
Eth
ern
et 1
0/1
00
+
-
2
1
3 4
5
6
ON
OF
F
2.
If not already done, record the MAC address from either the shipping box label or the label on this card for
future reference (see the
section).
3.
Remove the mini-slot cover from the UPS. Retain the screws.
NOTE
If another card is already installed with an attached communication cable, disconnect the
cable and then remove the card.
4.
To prevent electrostatic discharge (ESD), place one hand on a metal surface, such as the UPS rear panel.
5.
Slide the card into the open slot and secure it with the screws removed in
(see
