8
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
Figure 8. Update Driver Software Window – Update Successful
9.
Click
Close
.
10. Either obtain the DHCP-assigned IP address or manually enter a fixed IP address:
•
To obtain the IP address assigned through DHCP, continue to the
Obtain a DHCP-Assigned IP Address
section.
•
To manually enter a static (fixed) IP address for the card’s network connection, go to the
section.
NOTE
By default, the PXGMS card requests an IP address through DHCP when connected to a
network.
O
Obbttaaiinn aa D
DH
HC
CP
P--A
Assssiiggnneedd IIP
P A
Addddrreessss
NOTE
If connecting PredictPulse via an Eaton wireless modem, refer to the document
Connecting a NetComm Wireless NTC-140W Series Router to an Eaton Network Card
rather than this section.
To obtain the IP address through DHCP:
1.
Ensure the PXGMS card is still connected to the computer over the USB cable. Also ensure that the
network cable is connected from the PXGMS card Ethernet port to the network connection.
2.
If your Web browser already open to the default IP address, go to step 3. Otherwise, perform the
following:
a.
Open your Web browser.
b.
Enter:
https://169.254.0.101
for firmware 2.6.0 or later,
http://192.168.200.101
for earlier firmware
versions.
c.
Log on as administrator.
•
For firmware 2.6.5 and higher the username is “admin” and the default password is the card's
MAC address (case sensitive with no colons).
For example: Card's MAC address: 00:E0:D8:FF:C0:C4
–
Administrator name: admin
–
Password: 00E0D8FFC0C4
