Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 06
5
Figure 4. Install the Ethernet Cable
Id
e
n
t
P
o
w
e
r
A
c
t
1
0
0
P
X
G
M
S
U
P
S
R
e
s
ta
r
t
T
X
R
X
S
e
tu
p
C
M
N
S
ta
tu
s
D
H
C
P
E
M
P
E
th
e
r
n
e
t
1
0
/1
0
0
+
-
4.
Wait for the power light and status light on the installed card to illuminate. This takes about two minutes.
5.
Open a Web browser and type the default IP address (
https://169.254.0.101
for firmware 2.6.0 or later,
http://192.168.200.101
for earlier firmware versions).
6.
Did the Power Xpert Gateway software open to the PXGMS page?
•
If yes, the driver has already been installed automatically. Either verify the IP address assigned
through DHCP or manually enter a static (fixed) IP address for the card’s network connection:
a.
To verify the DHCP-assigned IP address, go to
of the
Obtain a DHCP-Assigned IP Address
section.
b.
To manually enter a fixed IP address, go to
•
If no, the driver has not been installed. Go to the
Install the USB Driver Software
section to confirm
that you have the most current USB Driver software. If not, install or update the USB Driver software.
