Connecting a NetComm Wireless NTC-140W Router to an Eaton® Network Card
P-164000722—Rev 04
9
R
Ruunn tthhee P
PrreeddiiccttP
Puullssee W
Wiizzaarrdd
To run the PredictPulse Wizard (
), connect a laptop or personal computer as follows.
For a
PXGX-UPS
card, using an RJ-45 Ethernet cable, connect the laptop or personal computer to the card’s
Downstream
port
For a
PXGMS
or
Network-M2
card, using an RJ-45 Ethernet cable, connect the laptop or personal computer to
the
LAN/WAN
port on the NTC-140W Series router
Run the PredictPulse Wizard (
). The Eaton PredictPulse window displays (see
Figure 16. PredictPulse Wizard Initial Display
Enter the Organization Code and customer E-Mail Address and click
Begin Registration
. The
PredictPulse
Device Activation
window displays (see
Figure 17. PredictPulse Device Activation Window
Enter the IP address or a range of IP addresses to continue. The wizard attempts to connect to a UPS at that
address.
Connecting a NetComm Wireless NTC-140W Series Router to an Eaton
Summary of Contents for Power Xpert Meter 2000
Page 16: ...P 16400072204 P 164000722 04...
