2
Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04
IInnssttaallll tthhee C
Caarrdd
NOTE
The hot-swappable PXGX UPS card can be installed without turning off the UPS or
disconnecting the load.
To install the PXGX UPS card:
1.
Verify that all six DIP switches on the card are in the
OFF
position (see
).
Figure 1. Verify DIP Switches are OFF
6 5 4 3 2 1
OFF
ON
2.
If not already done, record the MAC address for future reference (see the
section).
3.
Remove the X-slot
®
cover from the UPS. Retain the screws.
NOTE
If another card is already installed with an attached communication cable, disconnect the
cable and then remove the card.
4.
To prevent electrostatic discharge (ESD), place one hand on a metal surface, such as the UPS panel.
5.
Slide the card into the open slot and secure with the screws removed in
(see
).
Figure 2. Secure the PXGX UPS Card
6.
From your laptop, go to
.
Power Xpert Gatewa
y
PXGX UP
S
E
M
P
Upstrea
m
Downstrea
m
10
0
10
0
Ac
t
Ac
t
Setu
p
Restar
t
Statu
s
DH
C
P
Iden
t
Powe
r
Summary of Contents for Power Xpert
Page 24: ...16495024004 164950240 04...
