COMMUNICATION
EATON
Powerware
®
225 kVA PDU Installation and Operation Manual
S
164201629 Rev D
www.powerware.com
7−7
7.4.3
Connect the Card
To connect the card to the computer and start the configuration:
1.
Plug the RJ−45 end of the supplied configuration cable (labeled PC") into the
COM port on the card.
Verify that you have used the port labeled COM." The other ports on the card
will not work for configuration.
2.
Plug the other end of the serial cable into the serial COM port on the computer.
3.
Open your terminal emulation program (such as HyperTerminal).
4.
Select the appropriate serial connection (such as COM1). See Figure 7-4(a).
(a)
(b)
(c)
Figure 7-4. (a) Select Connection, (b) Configure Port Settings, and (c) Enter Configuration Password
5.
Set the serial line to 9600 baud, No parity, 8 data bits, 1 stop bit, and no flow
control [see Figure 7-4(b)].
6.
Verify that the PDU logic power is turned on.
7.
After a few seconds, press
Enter
. The Password prompt appears [see
If the Password prompt does not appear, press
Enter
again. If it still does not
appear, check the following conditions:
S
Verify the serial line is set to 9600 baud, No parity, 8 data bits, 1 stop bit, and
no flow control.
S
If the serial line settings are correct, check the cabling to verify all connections
are secure.
S
Verify that the terminal program is on the correct communication port for the
serial connection.
S
Verify that the card has power (one or more LEDs on the card are illuminated).
The PDU logic power should be turned on.
8.
Type your
password
(the default is
admin
) and press
Enter
. The Main Menu
screen appears.
Summary of Contents for Powerware 225 kVA Three-Phase Power Distribution...
Page 141: ......
Page 142: ...164201629D 164201629 D...
