Eaton 5115 Rack-Mount UPS (500–1500 VA) User's Guide
S
164201449 Rev B
www.eaton.com/powerquality
35
Chapter 4
Operation
This section describes:
S
Turning the UPS on and off
S
Starting the UPS on battery
S
Standby mode
S
The UPS front panel and indicators
S
Initiating the self‐test
Turning the UPS On
After the UPS is connected to a power outlet, the UPS enters Standby
mode.
To turn on the UPS, press and hold the
button until you hear the UPS
beep (approximately two seconds). The front panel indicators cycle
through a startup sequence while the UPS conducts a self‐test. When
the self-test is complete, the UPS enters Normal mode. The
,
Load 1, and Load 2 indicators illuminate indicating that power is available
from the UPS output receptacles.
Starting the UPS on Battery
NOTE
The UPS does not auto-detect the input frequency when starting on battery; the
default is the last frequency used by the UPS.
To turn on the UPS without using utility power, press and hold the
button for two seconds. The UPS starts up in Battery mode and supplies
battery power to your equipment.
