Page 34
9130 UPS-EN
8. Troubleshooting
The Eaton 9130 is designed for durable, automatic operation and also alerts you whenever potential
operating problems may occur. Usually the alarms shown by the control panel do not mean that the
output power is affected. Instead, they are preventive alarms intended to alert the user.
In general:
Events are silent conditions that are recorded in the Event Log as status information, such as
l
"Clock Set Done".
Notices are announced by a beep every 5 seconds, recorded in the Event Log, and displayed on
l
the LCD. Examples are "UPS on Battery" and "UPS on Bypass".
Alarms are announced by a beep every second, recorded in the Event Log, displayed on the
l
LCD, and the Alarm indicator illuminates. Examples are "Output Overload" and "Heatsink
Overtemperature".
Use the following troubleshooting chart to determine the UPS alarm condition.
8.1
Typical Alarms and Conditions
To check the UPS Status menu for a list of active alarms:
1.
Press any button on the front panel display to activate the menu options.
2.
Press the button until UPS STATUS displays.
3.
Press the Enter button to display the list of active alarms.
To check the Event Log for a history of conditions:
1.
Press any button on the front panel display to activate the menu options.
2.
Press the button until EVENT LOG displays.
3.
Press the Enter button to display the list of conditions.
You can also retrieve the entire Event Log in ASCII format. See "Retrieving the Event Log" on page 19.
The following table describes typical alarms and conditions.
Alarm or Condition
Possible Cause
Action
On battery
LED is on.
1 beep every 5 seconds.
A utility failure has occurred and
the UPS is in Battery mode.
The UPS is powering the equipment
with battery power. Prepare your
equipment for shutdown.
Battery low
The UPS is in Battery mode and
the battery is running low.
This warning is approximate, and the
actual time to shutdown may vary
significantly.
Depending on the UPS load and
number of Extended Battery Modules
(EBMs), the "Battery Low" warning
may occur before the batteries reach
25 % capacity. See table 23 on page
33 for estimated runtimes.
LED is flashing slowly.
1 beep every second.
On Bypass
The UPS is in Bypass mode.
The equipment transferred to bypass
utility power.
Battery mode is not available and
your equipment is not protected;
however, the utility power continues
to be passively filtered by the UPS.
Check for one of the following alarms:
overtemperature, overload, or UPS
failure.
LED is on.
1 beep every 5 seconds.
Batteries disconnected
The UPS does not recognize the
internal batteries.
If the condition persists, contact your
service representative.
The batteries are disconnected.
Verify that all batteries are properly
connected.
If the condition persists, contact your
service representative.
LED is on.
1 beep every second.
