INSTALLATION
Eaton 9140 UPS (7.5–10 kVA) User's Guide
S
164201622 Rev 3
www.eaton.com/powerquality
42
Installing the UPS Internal Batteries
To install the battery trays into the UPS cabinet:
1.
Verify that the output circuit breakers on the UPS rear panel are in
the OFF (O) position (see Figure 26 on page 44).
2.
Slide the battery trays into the cabinet (see Figure 24). Push each
tray in until the battery tray lock on the handle catches to lock the
tray in place.
Battery Tray Lock
Figure 24. Installing the Battery Trays
3.
Replace the UPS front cover and tighten the two front cover screws
(see Figure 25).
Figure 25. Replacing the UPS Front Cover
4.
If you are installing an optional EBM, continue to the following
section, “EBM Installation.” Otherwise, continue to “UPS
Installation” on page 45.
