Eaton 9170+ Flash Instructions
9170+ Flash Procedure
Eaton 9170+ Flash Procedure
IL153001EN
Page 12 of 12
6. To verify the power module and charger module firmware versions press the slot
button in the bottom left hand corner of the display. Then press the down arrow
button until it reads a slot with a power/ charger module in it. The slots are
identified by a number in the upper right hand corner of the display.
7. After looking at each slot it is recommended to change the display back so that
the firmware version for the interface board is shown on the display
8. When finished press the escape button until the main menu is displayed and
proceed with the startup sequence in the user manual.
