CONFIGURATION
EATON
Powerware
®
Environmental Rack Monitor (ERM) User’s Guide
S
164201673 Rev 1
11
7.
Type
1
on the Main Menu to display the Rack Monitor Configuration
Menu screen (see Figure 9).
+============================================================================+
|
[ Rack Monitor Configuration Utility Main Menu ]
|
+============================================================================+
1. Rack Monitor Configuration
2. TH-Module Configuration
3. Access Control Table
4. Trap Receiver Table
5. Reset Configuration To Default
6. Restart Rack Monitor
0. Exit
Please Enter Your Choice => 1
+============================================================================+
|
[ Rack Monitor Configuration Menu ]
|
+============================================================================+
1. System Group
2. Control Group
3. Parameter Group
4. Email Group
0. Return to previous menu
Please Enter Your Choice => _
Figure 9. ERM Configuration Menu
Configure the System Group Parameters
To configure the IP address, Gateway address, and Network Mask
parameters:
1.
Type
1
on the Rack Monitor Configuration Menu screen to display
the System Group Configuration Menu screen (see Figure 10 and
Table 2).
2.
Type
0
to return to the Rack Monitor Configuration Menu screen.
NOTE
To complete the ERM configuration, continue to the following section, “Modify the
Control Group Parameters” on page 13 or connect the ERM through a Web browser (see
page 22).
