CONFIGURATION
EATON
Powerware
®
Environmental Rack Monitor (ERM) User’s Guide
S
164201673 Rev 1
19
+============================================================================+
|
[ TH-Module-2 Setup ]
|
+============================================================================+
1. TH-Module-2 Status : Auto
2. TH-Module-2 Name
: Desktop Sensor
0. Return to previous menu
Please Enter Your Choice => _
Figure 16. TH-Module-2 Setup Screen
3.
Type
0
to return to the TH-Module Configuration Menu screen.
4.
Type
0
again to return to the Main Menu.
Configure the Access Control Table
If you wish to use a workstation with SNMP Manager installed, or if you
wish to set more restrictive ERM access, use the access table to add
the IP address of the PCs on which you wish to modify the access
permissions.
1.
Type
3
on the Main Menu to display the Access Control Table
screen (see Figure 17).
2.
Type
1
on the Access Control Table screen to modify an entry in the
Access Control Table.
3.
Type
2
on the Access Control Table screen to reset an entry to the
default setting.
4.
Type
0
to return to the Main Menu.
NOTE
The configuration of Access Control Table is configured for SNMP and HTTP
Network Management. Access through Telnet or RS-232 is permitted only when using the
“Community Read/Write” password in the Control Group.
NOTE
The community strings entered in the Community String fields are visible only in the
RS-232 connection. The TELNET connection does not display the string. An asterisk “*” will
be shown in the field.
NOTE
If a “NotAccess” access right is associated with an IP address, the associate
workstation will not be able to display any information regarding the ERM, even if the
Community Read-Only string is entered.
