INTRODUCTION
EATON
BladeUPS
®
(12 kVA) User's Guide
S
164201649 Rev 4
www.eaton.com/powerquality
3
The BladeUPS Bar for parallel systems, mounted in the rear of an Eaton rack, provides
the required input and output connections for the paralleled UPSs and has a single
system-rated input connection. Figure 2 shows an example of a BladeUPS parallel
system.
The BladeUPS system can be installed with Eaton remote power panels and
rack-mounted power distribution systems.
BladeUPS
Module
BladeUPS
Module
Bottom Entry
Wireway
BladeUPS Bar
BladeUPS Module
Figure 2. Example of a BladeUPS Parallel System
Note the following guidelines when configuring your BladeUPS standalone module or
parallel system:
S
The BladeUPS module accommodates a maximum of four EBMs.
S
The EBM(s) for a standalone BladeUPS module can be mounted directly below the
BladeUPS module or, with rack side panels removed, in an adjacent rack to the left
of the rack containing the BladeUPS module.
S
The EBMs for a parallel system should be mounted in an adjacent rack to the left
of the rack containing the BladeUPS modules (rack side panels removed).
S
For consistent runtimes, each BladeUPS module in a parallel system should have
the same number of EBMs.
Summary of Contents for Powerware Series
