EATON
9395 Field Installed UPM Mechanical Installation Manual
S
164201717 Rev 3
www.eaton.com/powerquality
4−1
Chapter 4
Field Installed UPM Installation
4.1
Preliminary Installation Information
W
A
R
N
I
N
G
Installation should be performed only by qualified personnel.
Refer to the following while installing the Field Installed UPM (FI−UPM):
S
Chapter 3 for cabinet dimensions, equipment weight, wiring and terminal data, and
installation notes.
S
Do not tilt the cabinet more than
"
10° during installation.
S
The FI−UPM cabinet is installed on the left side of the UPS cabinet.
S
The FI−UPM cabinet is shipped with a debris shield covering the ventilation grill on
top of the unit. Do not remove the debris shield until installation is complete.
However, remove the shield before operating the UPS system. Once the debris
shield is removed, do not place objects on the ventilation grill.
S
A FI−UPM is always designated as UPM 4.
4.2
Unloading the FI−UPM Cabinet from the Pallet
The FI−UPM cabinet is bolted to a wooden pallet supported by wood skids. To remove
the pallet:
W
A
R
N
I
N
G
The FI−UPM cabinet is heavy (see Table 3-1 on page 3−2). If unpacking and unloading instructions are not
closely followed, the cabinet may tip and cause serious injury.
C
A
U
T
I
O
N
S
Do not tilt cabinets more than 10° from vertical.
S
Lift the cabinet only with a forklift or damage may occur.
NOTE
For the following steps, verify that the forklift or pallet jack is rated to handle the weight of the
cabinet (see Table 3-1 on page 3−2 for cabinet weight).
1.
If not already accomplished, use a forklift or pallet jack to move the cabinet to the
installation area, or as close as possible, before unloading from the pallet. If
possible, move the cabinet using the pallet. Insert the forklift or pallet jack forks
from the right side of the pallet (facing the cabinet), between the supports on the
bottom of the pallet (see Figure 3-6 on page 3−5 for the FI−UPM cabinet center of
gravity measurements).
2.
Remove the three bolts securing the left side shipping bracket to the cabinet and
three bolts securing the bracket to the pallet (see Figure 4-1). Remove the left
side shipping bracket. If installing the cabinet permanently, retain the shipping
bracket and securing hardware for later use.
Figure 4Table 4
