12
Instruction Booklet
IB150020EN
Effective June 2019
PXG950-4G installation manual
EATON
www.eaton.com
Basic PXG950 configuration via USB
Factory reset using USB
To factory reset the PXG950, one can use a USB drive . In the top
level directory of the USB, place a file named “LoadFactoryDefault”
(without any extension) . The file “LoadFactoryDefault” should
contain the service tag (serial number) of the Gateway device on
which one needs to perform factory reset . Connect the USB to the
Gateway and then power cycle the gateway device .
After the factory reset operation is successful the file will be auto-
matically deleted from the USB .
otee:
N
The SD card should have only one FAT32 partition and
“LoadFactoryDefault” should be the only file .
Static IP address setting using USB
The device by default will be configured to use DHCP . To find the
IP address, one could use a tool like Advanced IP Scanner to find IP
address by using the device MAC address .
The device also supports configuring the device IP address using
a USB drive . To set the device IP address using USB, create and
place a file named “01-network-manager-all .yaml” in the first FAT32
partition of the USB disk and reboot the PXG950 with the USB
connected .
Sample contents of the file are shown below .
This would set the device IP address: 10 .235 .1 .96, netmask:
255 .255 .254 .0, gateway: 10 .235 .0 .1 and nameservers:
51 .110 .232 .49,151 .110 .232 .100
Once the PXG950 is reconfigured upon boot up, the file on USB
drive “01-network-manager-all .yaml” is renamed to “01-network-
manager-all .yaml .bak” . It can be reused for performing forced
settings by renaming the file back to “01-network-manager-all .yaml” .
6 . Align the screw holes on the standard-mount bracket with the
screws and place the PXG950-4G onto the wall .
7 . Tighten the screws to secure the assembly to the wall .
