4
Instruction Booklet
IB150020EN
Effective June 2019
PXG950-4G installation manual
EATON
www.eaton.com
Table 7. RS-485 half-duplex pin definition details.
Pin
Signal
Characteristics
1
Data-
(–) TX/RX data
2
Data+
(+) TX/RX data
3
Not applicable
Not applicable
4
Not applicable
Not applicable
5
GND
Ground
6
Not applicable
Not applicable
7
Not applicable
Not applicable
8
Not applicable
Not applicable
9
Not applicable
Not applicable
10
GND
Ground
Installing your PXG950-4G
Professional installation instructions
Installation location
The product shall be installed at a location where the radiating
antenna is kept 20 cm (7 .9 in .) from nearby persons in its normal
operation condition in order to meet regulatory RF exposure require-
ments .
External antenna
Use only approved antenna(s) . Non-approved antenna(s) may
produce spurious or excessive RF transmitting power which may
lead to a violation of FCC/IC limits .
Federal Communication Commission interference statement
This device complies with Part 15 of the FCC Rules . Operation is
subject to the following two conditions:
1 . This device may not cause harmful interference, and
2 . This device must accept any interference received, including
interference that may cause undesired operation .
This equipment has been tested and found to comply with the limits
for a Class A digital device, pursuant to Part 15 of the FCC Rules .
These limits are designed to provide reasonable protection against
harmful interference in a residential installation . This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications . However, there is no
guarantee that interference will not occur in a particular installation .
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one of the following measures:
•
Reorient or relocate the receiving antenna .
•
Increase the separation between the equipment and receiver .
•
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected .
•
Consult the dealer or an experienced radio/TV technician for help .
FCC caution:
•
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate this equipment .
•
This transmitter must not be co-located or operating in conjunc-
tion with any other antenna or transmitter .
Radiation exposure statement:
This equipment complies with FCC radiation exposure limits for an
uncontrolled environment . This equipment should be installed and
operated with a minimum distance of 20 cm (7 .9 in .) between the
active transceiver and your body .
The country code selection is for a non-US model only and is not
available to all US model . Per FCC regulation, all WiFi products
marketed in the US must be fixed to US operation channels only .
Industry Canada statement
This device complies with Industry Canada license-exempt RSS
standard(s) . Operation is subject to the following two conditions:
1 . This device may not cause interference, and
2 . This device must accept any interference, including interference
that may cause undesired operation of the device .
