2
Eaton PXGMS Card Quick Start Instructions P-164000208—Rev 2
Section 1
Installation Checklist
1.
Verify that the following items are available:
o
Power Xpert Gateway Minislot (PXGMS) UPS Card package contents
(card, cable, Quick Start Instructions)
o
Phillips
®
screwdriver
o
Available USB port on a computer running Microsoft
®
Windows
®
o
Web browser (Microsoft Internet Explorer
®
version 8.0 and higher,
Mozilla
®
Firefox
®
, or Google Chrome™ are recommended)
2.
If you are going to use Dynamic Host Configuration Protocol (DHCP), provide
your local network administrator with the card's MAC address. The MAC
address is located on either the shipping box label or the label on this card.
o
MAC Address
_____________________________________________
3.
If you are not going to use DHCP to provide any of the settings listed below,
contact your local network administrator for the settings.
In the table below, check the
DHCP
check box or enter the values for manual
configuration.You will reference this data later in the procedure.
4.
If you need e-mail functionality, obtain the SMTP mail server's IP address or
host name. If using the SMTP host name, verify that you also have the
Name Server IP address (see Step 3).
o
SMTP (mail server) IP Address
or Host Name
_____________________________________________
Item
DHCP*
Manual Configuration
IPv4
o
Card IP Address:
________________________
Netmask:
________________________
Gateway:
________________________
DNS – Name Servers
o
Name Server #1:
________________________
Name Server #2:
________________________
Name Server #3:
________________________
DNS – Domain
o
Domain:
________________________
* The network administrator normally sets up the DHCP server to provide a static IP address each time
the card makes a DHCP request.
Summary of Contents for PXGMS Power Xpert Gateway Minislot UPS
Page 25: ......
Page 26: ...164950239 P 164000208 2 ...
