10
Eaton Rack Power Module
164201675—Rev 02
22..88
P
Plluugg--R
Reecceeppttaaccllee IInnssttaallllaattiioonn
To prevent mechanical damage, coil and secure any excess cable away from the floor.
To install the plug-receptacle RPM-3U/3Ui:
1.
Verify that the RPM-3U/3Ui is properly installed in the rack or wallmount brackets and that each circuit
breaker on the RPM-3U/3Ui front panel is in the OFF (O) position. The Power indicator should be off.
2.
If your rack has conductors for grounding or bonding of ungrounded metal parts, connect the ground cable
(not included) to the ground bonding screw on the RPM-3U/3Ui rear panel.
shows the location of
the ground bonding screw.
3.
Plug the equipment power cords into the RPM-3U/3Ui output receptacles.
NOTE 1
NOTE 2
The RPM-3U/3Ui receptacles are protected separately by each circuit breaker on the
front panel.
Confirm that the equipment connected to the RPM-3U/3Ui does not exceed the RPM-
3U/3Ui's capacity. See “
” for the maximum rating for each
receptacle.
(Optional) Use the supplied labels to mark the equipment loads.
4.
Plug the RPM-3U/3Ui input power cord into the UPS. Power on the UPS if not already on.
The Power indicator on the RPM-3U/3Ui illuminates.
Verify that the Alarm indicator is off. If the Alarm indicator is illuminated, see “
”.
5.
Make provision for any required cord retention or strain relief.
6.
For each receptacle to be monitored, turn its circuit breaker on the RPM-3U/3Ui front panel to the ON ( | )
position.
NOTE
If power to the RPM-3U/3Ui is interrupted, check each circuit breaker and reset if
necessary.
Figure 6. Ground Bonding Screw
ti
n
U
d
e
ri
w
d
r
a
H
ti
n
U
e
l
c
a
t
p
e
c
e
R
-
g
u
l
P
M5 External Ground
Bonding Screw
Summary of Contents for RPM-3U
