13
External Battery Cabinets
For the following steps, use pincer type pliers or a large flat blade screw driver to
straighten the securing tabs.
NOTE
For the following step, verify that the forklift or pallet jack is rated to handle the
weight of the cabinets (see Table 3-1 for cabinet weight).
NOTE
1. Carefully inspect the outer packaging for evidence of damage during transit.
CAUTION
Do not install a damaged cabinet. Report any damages to the carrier and contact an Eaton service
representative immediately.
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinets using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet .
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4. Remove the protective wood/carton container from the cabinet:
CAUTION
• Do not tilt the EBC cabinets more than 10° from vertical or the cabinets may tip over.
• Take care of drop when lift the EBC from carton.
While waiting for installation, protect the unpacked cabinet from moisture, dust, and
other harmful contaminants. Failure to store and protect the EBC properly may void
your warranty.
NOTE
a. Straighten the tabs securing the top panel of the wooden container to the side panels of the container.
b. Remove the top panel and retain for later use as a ramp in unloading the cabinet from the pallet.
c. Straighten the tabs securing the side panels of the container to the front and back panels of the
container.
d. Remove the side panels.
e. Straighten the tabs securing the front and back panels of the container to the bottom of the container.
f.
Remove the front and back panels.
5. Remove the inner protective packaging. Retain the parts kit box, ramp brackets, and ramp extension
packed at the top of the cabinet.
6. Recycle the remainder of the outer shipping container and the inner protective packaging in a responsible
manner.
7. Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading. If
damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
Summary of Contents for Single EBC
