Quick Installation Manual with MRF
Page 16 of 24
3. Save SHC Configuration in original MRF Project
Note!:
The original MRF project is the MRF project which is currently active for the
configuration. Normally this project is created during the initial installation of the SHC and
maintained after that.
Follow the next steps to synchronize the SHC configuration with the original used MRF Project.
The configuration includes Zones, devices, Macros, Planner programs, Cameras and System
configurations, etc.
1. Export the SHC Configuration (Always keep this file to be able to restore the SHC
configuration).
2. Open the original used MRF Project for your SHC in the new
MRF V2.42
or higher.
3. Right-click on the Smart Home Controller and select:
Scan Device new
(Only necessary if RF-Module firmware has been updated as well).
4. Right-click on the SHC Icon and select:
Settings
5. Navigate to
Devices & Zones
and click:
Import Configuration
6. Select the just exported SHC Configuration file (step 1) and click:
Open
7. The SHC configuration is imported and you should see the zones and changes in
device names and functions.
8. Click OK and Save the MRF Project. The SHC Configuration is now in synch with the
MRF project.
Remark: Use now the MRF Project to make changes to SHC Zones and Device
configurations, export it and import it into the SHC.
