5 Take XSoft-CoDeSys-2 into operation
5.6 Change the device parameter of the SWD module
SmartWire-DT Gateway EU5C-SWD-DP
01/13 MN120001Z-EN
www.eaton.eu
35
Figure 18:
Adjusting the DP parameters in XSoft-CoDeSys-2
“User parameters” tab
This is where the device parameters for the EU5C-SWD coordinator are con-
figured Table 7, page 68. In order to configure the "Online Replacement"
device parameter, for example, follow the steps below:
▶
Open the "User parameters" tab in the XSoft-CoDeSys-2 PLC Configura-
tion window.
▶
Click on the SWD coordinator's "Online Replacement" device parameter.
.
Figure 19:
Device parameter of the SWD coordinator in XSoft-CoDeSys-2
5.6 Change the device parameter of the SWD module
You can parameterize the startup behavior for each SWD module. By doing
this you define how the gateway reacts, if a module is not available. The
default setting is that all modules have to be available. However, the informa-
tion as to whether a module is available is also reported to the application via
the diagnosis so that the failure of a module can be reacted to individually
here
