15
Sonix Pbx Technical Manual
SONIX PBX TECHNICAL MANUAL
TM372 / A June 2022 www.eaton.com
4.4.2 Zone selection
Setting the unit to “zoned” operation as indicated on the
front panel allows the user to enter specific zoning for
the subsequent message to be broadcast into.
To enter the zoning information the user will require a
telephone capable of touch tone dialling to send the
appropriate command(s) to the unit for the user to select
zones.
To broadcast to specific zones, the user enters the
required zoning information when indicated by the unit
according to the flow chart below. Each zone requested,
is entered using the telephones key pad as shown
below:
Zone(s) required
1st Zone
2nd zone
3rd zone
Finish tone
1
* 0 1
---
---
#
6
* 0 6
---
---
Wait for time out prompt
1,9 & 5
* 0 1
* 0 9
* 0 5
#
2, 12, & 15
* 0 2
* 1 2
* 1 5
Wait for time out prompt
ote:
N
The user can either wait for the timeout to occur after entering
zoning information or press “#”.
Figure 9 – Zoning flow chart
ote:
N
The announcement if loaded will precede the call answered tone
(a series of bleeps) relayed over the telephone at the start of zoning.
Process
Input
Discard
User Input
No Input
