background image

Copyright © 2018 by Eaton, Moon Township, PA, USA. All rights 

reserved. No part of this document may be reproduced in any way 

without the express written approval of Eaton.

Specifications contained herein are subject to change without 

notice.  

EATON - CONFIDENTIAL AND PROPRIETARY NOTICE TO 

PERSONS RECEIVING THIS DOCUMENT AND/OR TECHNICAL 

INFORMATION IN THIS DOCUMENT, INCLUDING THE DRAWING 

AND INFORMATION CONTAINED THEREON, IS CONFIDENTIAL 

AND IS THE EXCLUSIVE PROPERTY OF EATON, AND IS MERELY 

ON LOAN AND SUBJECT TO RECALL BY EATON AT ANY TIME. 

BY TAKING POSSESSION OF THIS DOCUMENT, THE RECIPIENT 

ACKNOWLEDGES AND AGREES THAT THIS DOCUMENT CANNOT 

BE USED IN ANY MANNER ADVERSE TO THE INTERESTS OF 

EATON, AND THAT NO PORTION OF THIS DOCUMENT MAY BE 

COPIED OR OTHERWISE REPRODUCED WITHOUT THE PRIOR 

WRITTEN CONSENT OF EATON. IN THE CASE OF CONFLICTING 

CONTRACTUAL PROVISIONS, THIS NOTICE SHALL GOVERN THE 

STATUS OF THIS DOCUMENT. 

DISCLAIMER OF WARRANTIES AND LIMITATION OF LIABILITY 

The information, recommendations, descriptions and safety nota-

tions in this document are based on Eaton's ("Eaton") experience 

and judgment and may not cover all contingencies. If further infor-

mation is required, an Eaton sales office should be consulted. Sale 

of the product shown in this literature is subject to the terms and 

conditions outlined in appropriate Eaton selling policies or other 

contractual agreement between Eaton and the purchaser. THERE 

ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, 

EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF 

FITNESS FOR A PARTICULAR PURPOSE OR MERCHANTABILITY, 

OTHER THAN THOSE SPECIFICALLY SET OUT IN ANY EXISTING 

CONTRACT BETWEEN THE PARTIES. ANY SUCH CONTRACT 

STATES THE ENTIRE OBLIGATION OF EATON. THE CONTENTS OF 

THIS DOCUMENT SHALL NOT BECOME PART OF OR MODIFY 

ANY CONTRACT BETWEEN THE PARTIES. 

In no event will Eaton be responsible to the purchaser or user in 

contract, in tort (including negligence), strict liability or otherwise 

for any special, indirect, incidental or consequential damage or loss 

whatsoever, including but not limited to damage or loss of use of 

equipment, plant or power system, cost of capital, loss of power, 

additional expenses in the use of existing power facilities, or claims 

against the purchaser or user by its customers resulting from the 

use of the information, recommendations and descriptions con-

tained herein. 

Instruction Manual 

IM01005031E - Rev. 4

     

Effective March 2014

Eaton SPD Series for Mounting External

to Electrical Distribution Equipment

Eaton

Electrical Sector

1000 Eaton Boulevard

Cleveland OH 44122

United States

877-ETN-CARE (877-386-2273

Eaton.com

© 2018 Eaton

All Rights Reserved

Printed in USA

Publication No. IM01005031E  TBG01131

February 2018

Eaton is a registered trademark. 

All other trademarks are property of their 

respective owners.

Summary of Contents for SPD120480D3M















Reviews: