34
Tripp Lite by Eaton SmartPro Advanced User Guide 614-40195—Rev 01
2.
Use tools with insulated handles,
3.
Do not lay tools or metal parts on top of batteries,
4.
Wear rubber gloves and boots.
•
When replacing batteries, replace with the same type and number of batteries or battery packs. Contact
your service representative to order new batteries.
•
Proper disposal of batteries is required. Refer to your local codes for disposal requirements.
•
Never dispose of batteries in a fire. Batteries may explode when exposed to flame.
•
Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes and
may be extremely toxic.
•
Determine if the battery is inadvertently grounded. If inadvertently grounded, remove source from ground.
Contact with any part of a grounded battery can result in electrical shock. The likelihood of such shock can
be reduced if such grounds are removed during installation and maintenance (applicable to equipment and
remote battery supplies not having a grounded supply circuit).
•
ELECTRIC ENERGY HAZARD. Do not attempt to alter any battery wiring or connectors. Attempting to alter
wiring can cause injury.
•
Disconnect charging source prior to connecting or disconnecting battery terminals.
R
Reeppllaacciinngg tthhee IInntteerrnnaall B
Baatttteerryy
The internal battery is heavy. Use caution when handling the heavy batteries.
NOTE
A Phillips head screwdriver is needed to perform this procedure.
Table 23. Replacing the Internal Battery Steps
1 - Pull off the front panel by pressing the tabs on both sides.
2 - Disconnect the battery pack by separating the connectors (never pull on the
wires).
Summary of Contents for Tripp Lite SmartPro Series
