36
Tripp Lite by Eaton SmartPro Advanced User Guide 614-40195—Rev 01
Table 24. Replacing the UPS Equipped with a HotSwap MBP Steps (Continued)
Return to normal operation
1.
Check that the UPS is correctly connected to the HotSwap MBP module.
2.
Start the UPS by pressing the
button on the UPS control panel. LED (43)
"UPS ON - OK to switch" on the HotSwap MBP module goes ON (otherwise,
there is a connection error between the HotSwap MBP module and the UPS).
3.
Set switch (45) to Normal position. The red LED on the HotSwap MBP module
goes OFF.
66..66
R
Reeccyycclliinngg tthhee U
Usseedd EEqquuiippm
meenntt
Contact your local recycling or hazardous waste center for information on proper disposal of the used
equipment.
www.eaton.com/recycling
Do not dispose the battery or batteries in a fire. Batteries may explode. Proper disposal of batteries is
required. Refer to your local codes for disposal requirements.
Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and eyes.
It may be toxic. Do not discard the UPS or the UPS batteries in the trash. This product contains sealed,
lead acid batteries and must be disposed of properly. For more information, contact your local
recycling/reuse or hazardous waste center.
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal,
contact your local recycling/reuse or hazardous waste center.
Summary of Contents for Tripp Lite SmartPro Series
